Help for TSC Setting Tab

Setting TSC Parameters

The parameters specific to the Trigger and Sequencer Card are set and initialized here. A channel should be requested first and then different conditions/commands for running should be applied. (At the moment Dim option is not available!)

The TSC Device should be initialized putting the "Device Number" in the Number Entry and then "Request" button should be clicked to request the channel.

Different "Resistors" can be specified in a number of Number Entries which are

Clock Minimum
Trigger Count
Trigger Frequency
APV Latency
Cal Latency
FED Latency
Reset Latency

There are " Check Buttons and a Combo Box to select Trigger Conditions which are

Interrupt On
Inhibit Trigger
Calibration On
Reset On
and one of the three trigger types "INTERNAL"/"EXTERNAL"/"SOFTWARE" can be selected

One should select Calibration On and Reset On during Calibration run ONLY.

The Commands for TSC are the following

Reset APV
Reset Pll
Enable Trigger
Send Software Trigger

All these parameters/conditions and commands can be sent using Apply button. To run in the normal Pedestal mode one should select "INTERNAL" and Enable Trigger options ONLY. During Calibration run one MUST select Calibration On and Reset On options as well.

The DIM Option is not available at the moment !